Environmentally Conscious and Economically Sound Machine Dismantling Forum > Milwaukee
> For hp & tektronix 100MHZ dual oscilloscope scope probe
For hp & tektronix 100MHZ dual oscilloscope scope probe
Fit for HP, Tektronix & Most Other Digital/Analog Scopes
The most commonly used oscilloscope probe - A tool used every day by engineers and technicians
Specially designed, meeting IEC1010-2-031,600Vpp, CAT.II and fit for HP, Tektronix & most digital and analogue oscilloscopes with BNC connector.
Miniature probe tip compatible with a wide range of most scope accessories and adapters
Switchable 1X/10X attenuation, using a switch located on the probe head
BNC Connector with Protective Insulated Shroud
Detachable ground lead with rotating collar for easy measuring
Ergonomic Design, Single Piece, Durable, Molded Rubber Body
Superior performance and high reliability
Low Frequency Trimmer Adjustment:
Low frequency response can be matched to the oscilloscope by adjusting the compensation trimmer on the head of probe.
Connect the probe to the oscilloscope and to a 1KHz. Square wave source, the rise time should not exceed 10 microseconds (most oscilloscopes provide a probe compensation output). For X1/X10 probes, switch to the X10 position.
Set the oscilloscope to display two to three cycles and two to six vertical divisions.
Carefully adjust the trimmer tool to obtain the flattest tops to the square waves displayed on the oscilloscope, see illustrations below:
