Environmentally Conscious and Economically Sound Machine Dismantling Forum > Kenosha
> Tips and Advices
> Dismandling Recommendations
> Rotating display case carousel trophy figure store
Rotating display case carousel trophy figure store
Rotating Display Carousel 36" inches tall The unit is approximately 16 inches wide. Distance from the outside edge of the shelves in to the round middle column is 4 3/4" inches Top section - It has a groove on the inside for a banner/poster to fit into. The one that is in right now is a sports theme. You could make your own poster/banner real easy to replace the one that's in there to match the product your selling or your company name etc. Bottom - Lazy susan turntable (as seen in the picture) with 4 rubber cushions Condition - Used but in very good shape.The counter top it was set up on most of the trophy figures were visible without turning it so it rarely got turned. The turntable bearings are in brand new condition. It was only used to display trophy figures for 6 months otherwise it has been in storage since. As you can tell in the pictures that I had used this display to show trophy figures in a shop I was located at.The figures did need to be tightened so there are a couple of spots where you can see a small scratch or a round mark from the trophy bottoms. Trophy Figures seen in the picture are NOT INCLUDED and the white stickers have been removed. Yes this rotating display is used mainly to display trophy figures but I see no reason it couldn't be used for any lightweight item. Each shelve has a long thin curved section that is cut out (as seen in the picture). The reason is trophy figures have a stud that hang below the figure and that stud goes into the cut out section and is secured with a nut under the bottom of the shelve to keep it in place. Made out of plastic so you could drill holes into any part of it - the round columns inbetween the shelves are hollow so they can be modified. Assembly is easy - 3 shelves which includes the bottom lazy susan turntable - 3 round middle columns - 1 Top piece - 2 threaded rods with a heavy duty coupler for connecting the rods and a round ball cap on top to tighten the entire carousel.
Contact A to Z Trophy with any questions.
