Environmentally Conscious and Economically Sound Machine Dismantling Forum > Milwaukee
> Tips and Advices
> Polyurethane concrete sealer, two component, 5 gallons
Polyurethane concrete sealer, two component, 5 gallons
Mosaics 2-Component Polyurethane Clear Sealer (High-Gloss)
This item is for One 5 gallon Kit.
Coverage: Coverage at 2 mils wet film thickness is 240- 280 sq. ft gal.
Mosaics Polyurethane Clear Sealer is a 2-component, water-based, membrane forming sealer made of polyurethane formulated exclusively for existing, hardened decorative and colored concrete. When dry, it forms a super-hard, high-gloss clear sealer suitable for exterior or interior applications. Mosaics Polyurethane Clear Sealer helps dust-proof the surface and increase resistance to abrasion. Mosaics Polyurethane Clear Sealer dries to clear, durable, high-gloss sheen that seals and protects concrete against stains and water damage. Its non-clouding formula is non-flammable, environmentally safe, VOC compliant and is especially suitable for use on architectural, colored, sand blasted or exposed aggregate concrete.
Basic Use: Existing concrete and concrete products: Mosaics Polyurethane Clear Sealer is applied in light coats over existing concrete to preserve the color appearance and seal and protect against moisture damage and most stains. Uses: interior and exterior decorative concrete paving such as floors, driveways, patios, walkways, sidewalks and cart paths.
Seals colored and decorative concrete
Protects against water damage, food and oil stains.
Fast-cure, water-base formula, easy clean-up
High gloss, non-yellowing and wear resistant.
Suitable for exterior as well as interior use
Non-flammable & environmentally safe (V.O.C. <40 g/L)
Surpasses California AQMD rule 1113 requirements
Resistant to hot-tire pick-up, gasoline, transmission fluid, and motor oil
Composition: Mosaics Polyurethane Clear Sealer is a 2-component clear sealer made of a polyurethane resin, water, long alcohol and surfactant.
Colors and Finishes: The final appearance of concrete treated with Mosaics Polyurethane Clear Sealer will vary according to application technique and the absorption and composition of the concrete.
Clean-Up: Use soap and water promptly after application, before sealer is allowed to dry. Rinse equipment of any cleaning agent or soap residue.
Gloss Polish Application: If desired, apply Mosaics Gloss Polish to interior surfaces sealed with Mosaics Polyurethane Clear Sealer for greater gloss and protection. Refer to instructions on product data sheet and label for more information.
Dry Time: Mosaics Polyurethane Clear Sealer will dry completely in approximately 5 hours. Although weather conditions can slow down or speed-up dry time up to 8 hours, only mix and use the amount of sealer that can be applied within 4 hours. If desired, a second coat can be applied 8 hours after the first coat. Make certain the sealer is hard before resuming floor traffic. Allow 48 hours dry-time, after the final coat, before resuming automobile traffic.
Limitations: Mosaics Polyurethane Clear Sealer is not suitable for concrete subject to chemical or acid exposure, heavy wear, warehouse floors, sub grade water or continuous water submersion. When wet, sealed surfaces will be more slippery than unsealed surfaces. Not recommended for kitchen floors or smooth, wet pedestrian areas unless applied together with Mosaics Seal - Grip Plus additive. Not recommended for pool decks as sealer can be discolored by acid contact. Do not use on surfaces which will later receive concrete overlays, toppings, coatings, joint sealants or on areas of poor drainage or as a membrane barrier against hydrostatic water pressure.
