Environmentally Conscious and Economically Sound Machine Dismantling Forum > Kenosha
> Welding and Laser Cutting
> MIG Welding with MIG Wire
> 12" lathe chuck standard tongue & groove soft jaws used
12" lathe chuck standard tongue & groove soft jaws used
12" Lathe Chuck Standard Tongue & Groove SOFT JAWS Used
These are used soft jaws. They have been machined on a fair amount already as pictured. Not sure who made them, they are numbered 1 thru 3 and each one is also numbered 315.
Bolt Holes Center To Center = 2 1/2"
Max Height Approx. (not including the tongue) =
Max length is about 4 7/16 inches (including the near worthless thin tabs on one end that can best be seen at the bottom of the last picture). The width is 1 7/16 inches. The ruler shown for scale is in marked in inches.
This item is offered with no reserve!
ALWAYS CHECK BELOW FOR ADDED INFORMATION as it may be important... added info will appear under any shaded areas near the BOTTOM of the page.
