Environmentally Conscious and Economically Sound Machine Dismantling Forum > Milwaukee
> Welding and Laser Cutting
> TIG Welding of Non Ferrous Metals
> New clarke 180EN mig welder kit 220V gas/no gas
New clarke 180EN mig welder kit 220V gas/no gas
*NEW* Clarke USA 180EN MIG/Fluxcore (220V) Wire Welder KIT plus regulator, helmet, welding gloves, and welding cart!
This NEW in factory sealed box Clarke 180EN MIG/Fluxcore 220V Wire Feed Welder plus regulator, helmet, welding gloves, and welding cart is easily converted from Fluxcore to Gas welding and will weld 1/4 in. steel in a single pass! Electronic wire speed control and 6 variable heat settings allow you to precisely adjust the welder to your needs and is fan cooled for better performance. Operates on 220 volt electrical supply. You will be getting this NEW in factory sealed box Clarke 180EN welder along with gas regulator, welding cart, welding gloves, welding helmet, roll of wire, chipping hammer/brush, welding mask, and manual as well.
* 6 power settings for maximum welding control
* Welds 1/4" in a single pass
* Solid state electronic heat control with large PC board for better wire speed control.
* Weld steel, aluminum, stainless, copper and cast, requires correct wire and gas.
* Operates from standard 220 VAC.
* Automatic thermal safety switch prevents overload.
* Mig gun with full On / Off safety control.
* Mig Gun is non-live with built in gas shut off.
* Simple to operate and portable.
* Max Open-Circuit Voltage: 30
* Variable wire feed control 0 - 700 IPM
* Circuit Breaker Req: 25 amps
* Duty Cycle: 20% at 100% output
* Duty Cycle: 30% at 85% output
